EFFECT OF MODELING LIQUIDS ON THE SURFACE OF COMPOSITE RESIN – A LITERATURE REVIEW
Abstract
The present study focused on composite resin modelers commonly used in contemporary dentistry to facilitate the final sculpting process in composite resin restorations. A literature review was conducted by consulting databases to compile a comparative table illustrating differences and the studies covered. Article selection was limited to English publications with no temporal constraints. Out of a total of 228 titles found, 19 were related to the technique, but only 4 articles were considered, as they exclusively addressed composite resin modelers. This review highlighted potential alterations in the mechanical, optical, and/or surface properties of composite resins. However, the application of composite resin modelers has shown varied results in the short term, with neutral or positive impacts in some studies and negative outcomes in others. There is a noticeable lack of scientific evidence in the literature definitively recommending or discouraging the use of these modelers. Therefore, the use of composite resin modelers is not contraindicated, but clinicians opting for their use are advised to also perform thorough polishing of the restoration and conduct long-term follow-ups.
Author Biographies
Universidade São Judas Tadeu.
Universidade São Judas Tadeu.
Universidade São Judas Tadeu.
Bacharel em Odontologia (Bolsista IC - CNPq), Mestre em Dentistica Operatória (Bolsista MS I/MS II - FAPESP) e PhD em Periodontia (Bolsista PROSUP - CAPES) pela Universidade Guarulhos, Professor celetista e coordenador do curso de Odontologia. Professor dos programas de graduação e pós-graduação stricto sensu (mestrado e doutorado) da Universidade de Mogi das Cruzes (UMC). Professor do curso de Odontologia da Universidade São Judas Tadeu (USJT). Pesquisador visitante do Departamento de Cariologia e Dentistica Operatória da Tokyo Medical and Dental University (Japão).
Universidade Guarulhos - UNG.
References
ALBINO, L. G.; RODRIGUES, J. A.; KAWANO, Y.; CASSONI, A. Knoop microhardness and FT-Raman evaluation of composite resins: influence of opacity and photoactivation source. Braz Oral Res., v. 25, n. 3, p. 267-73, 2011 May/jun. 2011 DOI: https://doi.org/10.1590/s1806-83242011000300013 DOI: https://doi.org/10.1590/S1806-83242011000300013
BARCELLOS, D. C.; PUCCI, C. R.; TORRES, C. R.; GOTO, E. H.; INOCENCIO, A. C. Effects of resinous monomers used in restorative dental modeling on the cohesive strength of composite resin. J Adhes Dent., v. 10, n. 5, p. 351-4, oct. 2008.
BAYRAKTAR, E. T.; ATALI, P. Y.; KORKUT, B.; KESIMLI, E. G.; TARCIN, B.; TURKMEN, C. Effect of Modeling Resins on Microhardness of Resin Composites. Eur J Dent., v. 15, n. 3, p. 481-487, jul. 2021 DOI: https://doi.org/10.1055/s-0041-1725577 DOI: https://doi.org/10.1055/s-0041-1725577
CHAVES, E. T.; VALENTE, L. L.; MÜNCHOW, E. A. Full analysis of the effects of modeler liquids on the properties of direct resin-based composites: a meta-analysis review of in vitro studies. Clin Oral Investig., v. 27, n. 7, p. 3289-3305, jul. 2023 DOI: https://doi.org/10.1007/s00784-023-05062-7 DOI: https://doi.org/10.1007/s00784-023-05062-7
DA ROSA RODOLPHO, P. A.; DONASSOLLO, T. A.; CENCI, M. S.; LOGUÉRCIO, A. D.; MORAES, R. R.; BRONKHORST, E. M.; OPDAM, N. J.; DEMARCO, F. F. 22-Year clinical evaluation of the performance of two posterior composites with different filler characteristics. Dent Mater, v. 27, n. 10, p. 955-63, oct. 2011 DOI: https://doi.org/10.1016/j.dental.2011.06.001 DOI: https://doi.org/10.1016/j.dental.2011.06.001
DE PAULA, F. C.; VALENTIN, R. DE S.; BORGES, B. C.; MEDEIROS, M. C.; DE OLIVEIRA, R. F.; DA SILVA, A. O. Effect of Instrument Lubricants on the Surface Degree of Conversion and Crosslinking Density of Nanocomposites. J Esthet Restor Dent., v. 28, n. 2, p. 85-91, mar./apr. 2016 DOI: https://doi.org/10.1111/jerd.12182 DOI: https://doi.org/10.1111/jerd.12182
KIM, M.; JO, D. W.; KHALIFAH, S. A.; YU, B.; HAYASHI, M.; KIM, R. H. Shear Bond Strength of Composite Diluted with Composite-Handling Agents on Dentin and Enamel. Polymers (Basel), v. 14, n. 13, p. 2665, 30 jun. 2022 DOI: https://doi.org/10.3390/polym14132665 DOI: https://doi.org/10.3390/polym14132665
KOSEWSKI, J.; KOSEWSKI, P, Mielczarek A. Influence of Instrument Lubrication on Properties of Dental Composites. Eur J Dent., v. 16, n. 4, p. 719-728, oct. 2022 DOI: https://doi.org/10.1055/s-0042-1743144 DOI: https://doi.org/10.1055/s-0042-1743144
KRAJANGTA, N.; NINBANJONG, S.; KHOSOOK, S.; CHAITONTUAK, K.; KLAISIRI, A. Effects of Immediate Coating on Unset Composite with Different Bonding Agents to Surface Hardness. Eur J Dent., v. 16, n. 4, p. 828-832, oct. 2022 DOI: https://doi.org/10.1055/s-0041-1740221 DOI: https://doi.org/10.1055/s-0041-1740221
KUTUK, Z. B.; ERDEN, E.; AKSAHIN, D. L.; DURAK, Z. E.; DULDA, A. C. Influence of modeling agents on the surface properties of an esthetic nano-hybrid composite. Restor Dent Endod., v. 45, n. 2, p. e13, 29 jan. 2020 DOI: https://doi.org/10.5395/rde.2020.45.e13 DOI: https://doi.org/10.5395/rde.2020.45.e13
MAIA, T. S.; LIMA, T. D.; RAMOS, V. M.; FARIA-E-SILVA, A. L.; MENEZES, M. S. Effect of modeling liquids on resin composite roughness and color parameters after staining and toothbrushing. Braz Oral Res., v. 37, p. e024, 31 mar. 2023 DOI: https://doi.org/10.1590/1807-3107bor-2023.vol37.0024 DOI: https://doi.org/10.1590/1807-3107bor-2023.vol37.0024
OLIVEIRA, P. H. C.; OLIVEIRA, J. A. P.; CASSONI, A.; RODRIGUES, J. A. Performance clínica de restaurações em dentes posteriores com resinas de Nanoparticulas/nanohíbridas – avaliação de 6 meses. Revista Saúde UnG., v. 5, n. 4, p. 5-13, 2011. http://revistas.ung.br/index.php/saude/article/view/1174/1255
PAOLONE, G.; MAZZITELLI, C.; JOSIC, U.; SCOTTI, N.; GHERLONE, E.; CANTATORE, G.; BRESCHI, L. Modeling Liquids and Resin-Based Dental Composite Materials-A Scoping Review. Materials (Basel), v. 15, n. 11, p. 3759, 24 may. 2022 DOI: https://doi.org/10.3390/ma15113759 DOI: https://doi.org/10.3390/ma15113759
PEREIRA, P. L.; PEREIRA, R.; SILVA, B. G.; LINS, R. B.; LIMA, D. A.; AGUIAR, F. H. Effect of wetting agent coverage on the surface properties of resin composite submitted to brushing and staining cycles. J Clin Exp Dent., v. 13, n. 8, p. e795-e801, 1 aug 2021 DOI: https://doi.org/10.4317/jced.58311 DOI: https://doi.org/10.4317/jced.58311
PORTO, J. A. S.; MUNCHOW, E. A.; BRONDANI, L. P.; CENCI, M. S.; CENCI, T. P. Effects of modeling liquid/resin and polishing on the color change of resin composite. Braz. Oral Res., v. 30, n. 1, p. e88, 2016 DOI: https://doi.org/10.1590/1807-3107BOR-2016.vol30.0088
SCHOILEW, K.; FAZELI, S.; FELTEN, A.; SEKUNDO, C.; WOLFF, D.; FRESE, C. Clinical evaluation of bulk-fill and universal nanocomposites in class II cavities: Five-year results of a randomized clinical split-mouth trial. J Dent., v. 128, 2023 DOI: https://doi.org/10.1016/j.jdent.2022.104362 DOI: https://doi.org/10.1016/j.jdent.2022.104362
SEDREZ-PORTO, J. A.; MÜNCHOW, E. A.; BRONDANI, L. P.; CENCI, M. S.; PEREIRA-CENCI, T. Effects of modeling liquid/resin and polishing on the color change of resin composite. Braz Oral Res., v. 30, n. 1, p. S1806-83242016000100275, 18 aug 2016. PMID: 27556554 DOI: https://doi.org/10.1590/1807-3107BOR-2016.vol30.0088 DOI: https://doi.org/10.1590/1807-3107BOR-2016.vol30.0088
TUNCER, S.; DEMIRCI, M.; TIRYAKI, M.; UNLÜ, N.; UYSAL, Ö. The effect of a modeling resin and thermocycling on the surface hardness, roughness, and color of different resin composites. J Esthet Restor Dent., v. 25, n. 6, p. 404-19, dec. 2013 DOI: https://doi.org/10.1111/jerd.12063 DOI: https://doi.org/10.1111/jerd.12063
YAZICI, A. R.; KUTUK, Z. B.; ERGIN, E.; KARAHAN, S.; ANTONSON, S. A. Six-year clinical evaluation of bulk-fill and nanofill resin composite restorations. Clin Oral Investig., v. 26, n. 1, p. 417-426, jan. 2022 DOI: https://doi.org/10.1007/s00784-021-04015-2 DOI: https://doi.org/10.1007/s00784-021-04015-2
License
Copyright (c) 2024 RECIMA21 - Revista Científica Multidisciplinar - ISSN 2675-6218
This work is licensed under a Creative Commons Attribution 4.0 International License.
Os direitos autorais dos artigos/resenhas/TCCs publicados pertecem à revista RECIMA21, e seguem o padrão Creative Commons (CC BY 4.0), permitindo a cópia ou reprodução, desde que cite a fonte e respeite os direitos dos autores e contenham menção aos mesmos nos créditos. Toda e qualquer obra publicada na revista, seu conteúdo é de responsabilidade dos autores, cabendo a RECIMA21 apenas ser o veículo de divulgação, seguindo os padrões nacionais e internacionais de publicação.